Pass-Code Reset
Pre-FUSE Navigation/Non Navigation
If you don’t have a Mitsubishi FUSE system you will to use these steps listed below to reset Bluetooth pass-code Power the HandsFree system up (ignition on for > 5 seconds) Make sure no bu... Read MoreFUSE without Navigation – Single Line before 2014
Make sure the power off for the radio Press and release the following buttons in this order 1 RPT (repeat button), <<SEEK, SEEK>> (left seek then right seek or backward then forward) the... Read MoreFUSE without Navigation – Single Line Display 2014 & Up
Make sure the power off for the radio Press and release the following buttons in this order 1 RPT (repeat button), <<SEEK, SEEK>> (left seek then right seek or backward then forward) the... Read MoreFUSE without Navigation but touchscreen display 2014 & UP
In any screen, while holding down the MENU KEY touch or press the lower left corner of the screen for about 2 seconds, release the touch or press in the right top corner for about 2 seconds until the... Read MoreFUSE with Navigation System before 2014
Press and hold the SET and NAVI buttons at the same time for 4-5 seconds. Press Hand FREE MODULE button or (on the screen) Press UNLOCK Select YES to confirmation question We advise to turn off the ... Read MoreFUSE with Navigation System 2014
Press and hold the SETTINGS and MAP button at the same time for 4-5 seconds. Press the HANDS FREE MODULE button Press UNLOCK Select YES to the confirmation question We advise to turn off the vehicle... Read More
March 8