Blog

Pre-FUSE Navigation/Non Navigation


March 8, 2016 Facebook Twitter LinkedIn Google+ Bleutooth,Mitsubishi Bluetooth,Pass-Code Reset


If you don’t have a Mitsubishi FUSE system you will to use these steps listed below to reset Bluetooth pass-code

  1. Power the HandsFree  system up (ignition on for > 5 seconds) Make sure no button press are made.
  2. Hold down the HANG-UP button for 2 seconds and release, 3 consecutive times with 10 seconds of the initial button press.
  3. HandsFree system will clear the pass-code and set the pass-code to disabled
  4. For confirmation of success press the SPEECH button and ensure the module says “HandsFree system ready”

We advise to turn off the vehicle after going to the process and turn it on after to to find out that the pass-code has been reset. Press the SPEECH BUTTON and the voice system will say “HandsFree System Ready”.

If you tried these steps for at least three times with no success we advise to take the vehicle to a Mitsubishi dealer so they perform a hard reset by unplugging the battery for about 15-20 minutes.

Comments